ZyXEL Communications Parental Control Gateway HS100/HS100W - Manual (Page 95)

HomeSafe User’s Guide
7-2 Wireless Security
Figure 7-2 WLAN : Wireless : No Security
The following table describes the labels in this screen.
Table 7-1 WLAN : Wireless : No Security
LABEL DESCRIPTION
Security Choose from one of the security features listed in the drop-down box.
¾
No Security
¾ Static WEP
¾ WPA-PSK
¾ WPA
¾ 802.1x + Dynamic WEP
¾ 802.1x + Static WEP
¾ 802.1x + No WEP
Preamble Select a preamble type from the drop-down list menu. Choices are Long, Short and
Dynamic. The default setting is Long.
See the section on preamble for more information.
802.11 Mode Select 802.11b Only to allow only IEEE 802.11b compliant WLAN devices to associate
with the HomeSafe.
Select 802.11g Only to allow only IEEE 802.11g compliant WLAN devices to associate
with the HomeSafe.
Select Mixed to allow either IEEE802.11b or IEEE802.11g compliant WLAN devices to
associate with the HomeSafe. The transmission rate of your HomeSafe might be
reduced.
Max. Frame
Burst Enable Maximum Frame Burst to help eliminate collisions in mixed-mode networks
(networks with both IEEE 802.11g and IEEE 802.11b traffic) and enhance the
performance of both pure IEEE 802.11g and mixed IEEE 802.11b/g networks. Maximum
Frame Burst sets the maximum time, in microseconds, that the HomeSafe transmits
IEEE 802.11g wireless traffic only.
Type the maximum frame burst between 0 and 1800 (650, 1000 or 1800
recommended). Enter 0 to disable this feature. The default is 650.
Apply Click Apply to save your changes back to the HomeSafe.