ZyXEL Communications Parental Control Gateway HS100/HS100W - Manual (Page 309)

HomeSafe User’s Guide
33-2 Remote Management
Table 33-1 Menu 24.11 – Remote Management Control
FIELD DESCRIPTION EXAMPLE
Port This field shows the port number for the service or protocol. You may
change the port number if needed, but you must use the same port
number to access the HomeSafe. 23
Access Select the access interface (if any) by pressing [SPACE BAR], then
[ENTER] to choose from: LAN only, WAN only, ALL or Disable. LAN Only
(default)
Secure Client
IP The default 0.0.0.0 allows any client to use this service or protocol to
access the HomeSafe. Enter an IP address to restrict access to a client
with a matching IP address. 0.0.0.0
Once you have filled in this menu, press [ENTER] at the message "Press ENTER to Confirm or ESC to
Cancel" to save your configuration, or press [ESC] to cancel.
33.1.1 Remote Management Limitations
Remote management over LAN or WAN will not work when:
1. A filter in menu 3.1 (LAN) or in menu 11.5 (WAN) is applied to block a Telnet, FTP or
Web service.
2. You have disabled that service in menu 24.11.
3. The IP address in the Secure Client IP field (menu 24.11) does not match the client IP
address. If it does not match, the HomeSafe will disconnect the session immediately.
4. There is an SMT console session running.
5. There is already another remote management session with an equal or higher priority
running. You may only have one remote management session running at one time.
6. There is a firewall rule that blocks it.