ZyXEL Communications Parental Control Gateway HS100/HS100W - Manual (Page 232)

HomeSafe User’s Guide
Internet Access 21-1
Chapter 21
Internet Access
This chapter shows you how to configure your HomeSafe for Internet access .
21.1 Introduction to Internet Access Setup
Use information from your ISP along with the instructions in this chapter to set up your
HomeSafe to access the Internet. There are three different menu 4 screens depending on whether
you chose Ethernet, PPTP or PPPoE Encapsulation. Contact your ISP to determine what
encapsulation type you should use.
21.2 Ethernet Encapsulation
From the main menu, type 4 to display Menu 4 - Internet Access Setup.
If you choose Ethernet in menu 4 you will see the next menu.
Figure 21-1 Menu 4 Internet Access Setup
The following table describes the fields in this menu.
Table 21-1 Menu 4: Internet Access Setup (Ethernet)
FIELD DESCRIPTION
ISP’s Name Enter the name of your Internet Service Provider, e.g., myISP. This information is
for identification purposes only.
Encapsulation Press [SPACE BAR] and then press [ENTER] to choose Ethernet. The
encapsulation method influences your choices for the IP Address field.
Service Type Press [SPACE BAR] and then [ENTER] to select Standard, RR-Toshiba
(RoadRunner Toshiba authentication method), RR-Manager (RoadRunner
Manager authentication method), RR-Telstra or Telia Login. Choose a
RoadRunner flavor if your ISP is Time Warner's RoadRunner; otherwise choose
Standard.
Note: DSL users must choose the Standard option only. The My Login, My Password and Login
Server fields are not applicable in this case.
My Login Enter the login name given to you by your ISP.
My Password Type your password again for confirmation.
Menu 4 - Internet Access Setup
ISP's Name= MyISP
Encapsulation= Ethernet
Service Type= Standard
My Login= N/A
My Password= N/A
Retype to Confirm= N/A
Login Server= N/A
Relogin Every (min)= N/A
IP Address Assignment= Dynamic
IP Address= N/A
IP Subnet Mask= N/A
Gateway IP Address= N/A
Network Address Translation= SUA Only