ZyXEL Communications Parental Control Gateway HS100/HS100W - Manual (Page 190)

HomeSafe User’s Guide
14-8 Remote Management Screens
Figure 14-6 Remote Management : SNMP
The following table describes the labels in this screen.
Table 14-5 Remote Management : SNMP
LABEL DESCRIPTION
SNMP Configuration
Get Community Enter the Get Community, which is the password for the incoming Get and GetNext
requests from the management station. The default is public and allows all requests.
Set Community Enter the Set community, which is the password for incoming Set requests from the
management station. The default is public and allows all requests.
Trusted Host If you enter a trusted host, your HomeSafe will only respond to SNMP messages
from this address. A blank (default) field means your HomeSafe will respond to all
SNMP messages it receives, regardless of source.
Trap
Community Type the trap community, which is the password sent with each trap to the SNMP
manager. The default is public and allows all requests.
Destination Type the IP address of the station to send your SNMP traps to.
SNMP
Service Port You may change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.