ZyXEL Communications Parental Control Gateway HS100/HS100W - Manual (Page 233)

HomeSafe User’s Guide
21-2 Internet Access
Table 21-1 Menu 4: Internet Access Setup (Ethernet)
FIELD DESCRIPTION
Retype to Confirm Enter your password again to make sure that you have entered is correctly.
Login Server The HomeSafe will find the RoadRunner Server IP if this field is left blank. If it does
not, then you must enter the authentication server IP address.
Relogin Every
(min)
This field is available when you select Telia Login in the Service Type field.
The Telia server logs the HomeSafe out if the HomeSafe does not log in
periodically. Type the number of minutes from 1 to 59 (30 recommended) for the
HomeSafe to wait between logins.
IP Address
Assignment If your ISP did not assign you a fixed IP address, press [SPACE BAR] and then
[ENTER] to select Dynamic, otherwise select Static and enter the IP address and
subnet mask in the following fields.
IP Address Enter the (fixed) IP address assigned to you by your ISP (static IP address
assignment is selected in the previous field).
IP Subnet Mask Enter the subnet mask associated with your static IP.
Gateway IP
Address
Enter the gateway IP address associated with your static IP.
Network Address
Translation Network Address Translation (NAT) allows the translation of an Internet protocol
address used within one network (for example a private IP address used in a local
network) to a different IP address known within another network (for example a
public IP address used on the Internet).
Choose None to disable NAT.
Choose SUA Only if you have a single public IP address. SUA (Single User
Account) is a subset of NAT that supports two types of mapping: Many-to-One and
Server.
Choose Full Feature if you have multiple public IP addresses. Full Feature
mapping types include: One-to-One, Many-to-One (SUA/PAT), Many-to-Many
Overload, Many- One-to-One and Server. When you select Full Feature you must
configure at least one address mapping set!
Please see the NAT chapter for a more detailed discussion on the Network Address
Translation feature.
When you have completed this menu, press [ENTER] at the prompt “Press ENTER to Confirm…” to save
your configuration, or press [ESC] at any time to cancel.
21.3 Configuring the PPTP Client
)
The HomeSafe supports only one PPTP server connection at any
given time.
To configure a PPTP client, you must configure the My Login and Password fields for a PPP connection
and the PPTP parameters for a PPTP connection.
After configuring My Login and Password for PPP connection, press [SPACE BAR] and then [ENTER]
in the Encapsulation field in Menu 4 -Internet Access Setup to choose PPTP as your encapsulation
option. This brings up the following screen.