ZyXEL Communications Parental Control Gateway HS100/HS100W - Manual (Page 323)

HomeSafe User’s Guide
Log Descriptions D-1
Appendix D
Log Descriptions
Configure centralized logs using the embedded web configurator; see the online help for
details. This appendix describes some of the log messages.
Chart 1 System Error Logs
LOG MESSAGE DESCRIPTION
%s exceeds the max.
number of session per
host! This attempt to create a NAT session exceeds the maximum number of
NAT session table entries allowed to be created per host.
Chart 2 System Maintenance Logs
LOG MESSAGE DESCRIPTION
Time calibration is
successful The router has adjusted its time based on information from the time
server.
Time calibration
failed The router failed to get information from the time server.
DHCP client gets %s A DHCP client got a new IP address from the DHCP server.
DHCP client IP
expired A DHCP client's IP address has expired.
DHCP server assigns The DHCP server assigned an IP address to a client.
SMT Login
Successfully Someone has logged on to the router's SMT interface.
SMT Login Fail Someone has failed to log on to the router's SMT interface.
WEB Login
Successfully Someone has logged on to the router's web configurator interface.
WEB Login Fail Someone has failed to log on to the router's web configurator interface.
TELNET Login
Successfully Someone has logged on to the router via telnet.
TELNET Login Fail Someone has failed to log on to the router via telnet.
FTP Login
Successfully Someone has logged on to the router via ftp.
FTP Login Fail Someone has failed to log on to the router via ftp.
NAT Session Table is
Full! The maximum number of NAT session table entries has been
exceeded and the table is full.
!! Phase 1 ID type
mismatch The ID type of an incoming packet does not match the local's peer ID
type.
!! Phase 1 ID content The ID content of an incoming packet does not match the local's peer