ZyXEL Communications Parental Control Gateway HS100/HS100W - Manual (Page 212)

HomeSafe User’s Guide
Introducing the SMT 17-1
Chapter 17
Introducing the SMT
This chapter explains how to access and navigate the System Management Terminal
and gives an overview of its menus.
17.1 SMT Introduction
The HomeSafe’s SMT (System Management Terminal) is a menu-driven interface that you can
access from a terminal emulator through the console port or over a telnet connection. This chapter
shows you how to access the SMT (System Management Terminal) menus via console port, how
to navigate the SMT and how to configure SMT menus.
17.1.1 Procedure for SMT Configuration via Console Port
Follow the steps below to access your HomeSafe via the console port.
Configure a terminal emulation communications program as follows: VT100 terminal emulation,
no parity, 8 data bits, 1 stop bit, data flow set to none, 9600 bps port speed.
Press [ENTER] to display the SMT password screen. The default password is “1234”.
17.1.2 Procedure for SMT Configuration via Telnet
The following procedure details how to telnet into your HomeSafe.
Step 1. In Windows, click Start (usually in the bottom left corner), Run and then type “telnet
192.168.1.1” (the default IP address) and click OK.
Step 2. Enter “1234” in the Password field.
Step 3. After entering the password you will see the main menu.
Please note that if there is no activity for longer than five minutes (default timeout period) after
you log in, your HomeSafe will automatically log you out. You will then have to telnet into the
HomeSafe again.
17.1.3 Entering Password
The login screen appears after you press [ENTER], prompting you to enter the password, as
shown next.
For your first login, enter the default password “1234”. As you type the password, the screen
displays an asterisk “*” for each character you type.
Please note that if there is no activity for longer than five minutes after you log in, your
HomeSafe will automatically log you out.
Figure 17-1 Login Screen
17.1.4 HomeSafe SMT Menu Overview
The following figure gives you an overview of the various SMT menu screens of your HomeSafe.
Enter Password : ****