ZyXEL Communications Parental Control Gateway HS100/HS100W - Manual (Page 279)

HomeSafe User’s Guide
28-2 SNMP Configuration
• GetNext - Allows the manager to retrieve the next object variable from a table or list within
an agent. In SNMPv1, when a manager wants to retrieve all elements of a table from an
agent, it initiates a Get operation, followed by a series of GetNext operations.
• Set - Allows the manager to set values for object variables within an agent.
• Trap - Used by the agent to inform the manager of some events.
28.2 Supported MIBs
The HomeSafe supports RFC-1215 and MIB II as defined in RFC-1213 as well as ZyXEL private
MIBs. The focus of the MIBs is to let administrators collect statistic data and monitor status and
performance.
28.3 SNMP Configuration
To configure SNMP, select option 22 from the main menu to open Menu 22 — SNMP
Configuration as shown next. The “community” for Get, Set and Trap fields is SNMP
terminology for password.
Figure 28-2 Menu 22 SNMP Configuration
The following table describes the SNMP configuration parameters.
Table 28-1 Menu 22 SNMP Configuration
FIELD DESCRIPTION EXAMPLE
SNMP:
Get Community Type the Get Community, which is the password for the incoming
Get- and GetNext requests from the management station. public
Set Community Type the Set community, which is the password for incoming Set
requests from the management station. public
Trusted Host If you enter a trusted host, your HomeSafe will only respond to
SNMP messages from this address. A blank (default) field means
your HomeSafe will respond to all SNMP messages it receives,
regardless of source. 0.0.0.0
Trap:
Community Type the trap community, which is the password sent with each
trap to the SNMP manager.
public
Destination Type the IP address of the station to send your SNMP traps to. 0.0.0.0
When you have completed this menu, press [ENTER] at the prompt “Press ENTER to confirm or ESC to
cancel” to save your configuration or press [ESC] to cancel and go back to the previous screen.
Menu 22 - SNMP Configuration
SNMP:
Get Community= public
Set Community= public
Trusted Host= 0.0.0.0
Trap:
Community= public
Destination= 0.0.0.0