ZyXEL Communications Parental Control Gateway HS100/HS100W - Manual (Page 229)

HomeSafe User’s Guide
20-8 Menu 3 LAN Setup
Figure 20-8 Menu 3.5.1 WLAN MAC Address Filter
The following table describes the fields in this menu.
Table 20-5 Menu 3.5.1 WLAN MAC Address Filter
FIELD DESCRIPTION
Active To enable MAC address filtering, press [SPACE BAR] to select Yes and press [ENTER].
Filter Action Define the filter action for the list of MAC addresses in the MAC address filter table.
To deny access to the HomeSafe, press [SPACE BAR] to select Deny Association and
press [ENTER]. MAC addresses not listed will be allowed to access the router.
The default action, Allowed Association, permits association with the HomeSafe. MAC
addresses not listed will be denied access to the router.
MAC Address Filter
Address Enter the MAC addresses (in XX:XX:XX:XX:XX:XX format) of the client computers that
are allowed or denied access to the HomeSafe in these address fields.
When you have completed this menu, press [ENTER] at the prompt “Press ENTER to confirm or ESC to
cancel” to save your configuration or press [ESC] to cancel and go back to the previous screen.
20.4.2 Configuring Roaming on the HomeSafe
Enable the roaming feature if you have two or more HomeSafe’s on the same subnet. Follow the
steps below to allow roaming on your HomeSafe.
Step 1. From the main menu, enter 3 to display Menu 3 – LAN Setup.
Step 2. Enter 5 to display Menu 3.5 – Wireless LAN Setup.
Menu 3.5.1 - WLAN MAC Address Filter
Active= No
Filter Action= Allowed Association
MAC Address Filter
Address 1= 00:00:00:00:00:00
Address 2= 00:00:00:00:00:00
Address 3= 00:00:00:00:00:00
Address 4= 00:00:00:00:00:00
Address 5= 00:00:00:00:00:00
Address 6= 00:00:00:00:00:00
Address 7= 00:00:00:00:00:00
Address 8= 00:00:00:00:00:00
Address 9= 00:00:00:00:00:00
Address 10= 00:00:00:00:00:00
Address 11= 00:00:00:00:00:00
Address 12= 00:00:00:00:00:00
Enter here to CONFIRM or ESC to CANCEL: