ZyXEL Communications Parental Control Gateway HS100/HS100W - Manual (Page 141)

HomeSafe User’s Guide
NAT Screens 9-11
)
Only one LAN computer can use a trigger port (range) at a
time.
Figure 9-8 Trigger Port
The following table describes the labels in this screen.
Table 9-7 Trigger Port
LABEL DESCRIPTION
# This is the rule index number (read-only).
Name Type a unique name (up to 15 characters) for identification purposes. All characters are
permitted - including spaces.
Incoming Incoming is a port (or a range of ports) that a server on the WAN uses when it sends out
a particular service. The HomeSafe forwards the traffic with this port (or range of ports)
to the client computer on the LAN that requested the service.
Start Port Type a port number or the starting port number in a range of port numbers.
End Port Type a port number or the ending port number in a range of port numbers.
Trigger The trigger port is a port (or a range of ports) that causes (or triggers) the HomeSafe to
record the IP address of the LAN computer that sent the traffic to a server on the WAN.
Start Port Type a port number or the starting port number in a range of port numbers.
End Port Type a port number or the ending port number in a range of port numbers.
Apply Click Apply to save your changes back to the HomeSafe.
Reset Click Reset to begin configuring this screen afresh.