ZyXEL Communications Parental Control Gateway HS100/HS100W - Manual (Page 119)

HomeSafe User’s Guide
8-2 WAN
Table 8-1 WAN : Route
LABEL DESCRIPTION
WAN
Traffic
Redirect The default WAN connection is "1' as your broadband connection via the WAN port
should always be your preferred method of accessing the WAN. The default priority of
the routes is WAN and then Traffic Redirect.
Apply Click Apply to save your changes back to the HomeSafe.
Reset Click Reset to begin configuring this screen afresh.
8.4 Configuring WAN ISP
To change your HomeSafe’s WAN ISP settings, click WAN, then the WAN ISP tab. The screen
differs by the encapsulation.
8.4.1 Ethernet Encapsulation
The screen shown next is for Ethernet encapsulation.
Figure 8-2 WAN ISP : Ethernet Encapsulation
The following table describes the labels in this screen.
Table 8-2 WAN ISP : Ethernet Encapsulation
LABEL DESCRIPTION
Encapsulation You must choose the Ethernet option when the WAN port is used as a regular
Ethernet.
Service Type Choose from Standard, Telstra (RoadRunner Telstra authentication method), RR-
Manager (Roadrunner Manager authentication method), RR-Toshiba (Roadrunner
Toshiba authentication method) or Telia Login.
The following fields do not appear with the Standard service type.
User Name Type the user name given to you by your ISP.
Password Type the password associated with the user name above.
Retype to Confirm Type the password again to make sure that you have entered it correctly.
Login Server IP
Address Type the authentication server IP address here if your ISP gave you one.