ZyXEL Communications Parental Control Gateway HS100/HS100W - Manual (Page 244)

HomeSafe User’s Guide
Static Route Setup 23-1
Chapter 23
Static Route Setup
This chapter shows how to setup IP static routes.
23.1 IP Static Route Setup
Step 1. To configure an IP static route, use Menu 12 – Static Routing Setup (shown next).
Figure 23-1 Menu 12 IP Static Route Setup
Step 2. Now, type the route number of a static route you want to configure.
Figure 23-2 Menu12.1 Edit IP Static Route
The following table describes the fields for Menu 12.1 – Edit IP Static Route Setup.
Table 23-1 Menu12.1 Edit IP Static Route
FIELD DESCRIPTION
Route # This is the index number of the static route that you chose in menu 12.1.
Route Name Type a descriptive name for this route. This is for identification purpose only.
Active This field allows you to activate/deactivate this static route.
Destination IP
Address This parameter specifies the IP network address of the final destination. Routing
is always based on network number. If you need to specify a route to a single
host, use a subnet mask of 255.255.255.255 in the subnet mask field to force the
network number to be identical to the host ID.
Menu 12.1 - Edit IP Static Route
Route #: 1
Route Name= ?
Active= No
Destination IP Address= ?
IP Subnet Mask= ?
Gateway IP Address= ?
Metric= 2
Private= No
fi l
Menu 12 - IP Static Route Setup
1. ________
2. ________
3. ________
4. ________
5. ________
6. ________
7. ________
8. ________
Enter selection number: