ZyXEL Communications Parental Control Gateway HS100/HS100W - Manual (Page 301)

HomeSafe User’s Guide
31-8 Firmware and Configuration File Maintenance
Step 5. Use the TFTP client (see the example below) to transfer files between the HomeSafe
and the computer. The file name for the firmware is “ras”.
Note that the telnet connection must be active and the HomeSafe in CI mode before and during
the TFTP transfer. For details on TFTP commands (see following example), please consult the
documentation of your TFTP client program. For UNIX, use “get” to transfer from the HomeSafe
to the computer, “put” the other way around, and “binary” to set binary transfer mode.
31.4.6 TFTP Upload Command Example
The following is an example TFTP command:
tftp [-i] host put firmware.bin ras
where “i” specifies binary image transfer mode (use this mode when transferring binary files),
“host” is the HomeSafe’s IP address and “put” transfers the file source on the computer
(firmware.bin – name of the firmware on the computer) to the file destination on the remote host
(ras - name of the firmware on the HomeSafe).
Commands that you may see in GUI-based TFTP clients are listed earlier in this chapter.