ZyXEL Communications Parental Control Gateway HS100/HS100W - Manual (Page 302)

HomeSafe User’s Guide
System Maintenance 32-1
Chapter 32
System Maintenance
This chapter leads you through SMT menus 24.8 to 24.10.
32.1 Command Interpreter Mode
The Command Interpreter (CI) is a part of the main system firmware. The CI provides much of
the same functionality as the SMT, while adding some low-level setup and diagnostic functions.
Enter the CI from the SMT by selecting menu 24.8. See the included disk or the zyxel.com web
site for more detailed information on CI commands. Enter 8 from Menu 24 — System
Maintenance. A list of valid commands can be found by typing help or ? at the command
prompt. Type “exit” to return to the SMT main menu when finished.
Figure 32-1 Command Mode in Menu 24
32.1.1 Command Syntax
The command keywords are in courier new font.
Enter the command keywords exactly as shown, do not abbreviate.
The required fields in a command are enclosed in angle brackets <>.
The optional fields in a command are enclosed in square brackets [].
The |symbol means “or”.
For example,
sys filter netbios config
means that you must specify the type of netbios filter and whether to turn it on or off.
32.1.2 Command Usage
A list of commands can be found by typing help or ? at the command prompt. Always type the
full command. Type exit to return to the SMT main menu when finished.
Menu 24 - System Maintenance
1. System Status
2. System Information and Console Port Speed
3. Log and Trace
4. Diagnostic
5. Backup Configuration
6. Restore Configuration
7. Firmware Update
8. Command Interpreter Mode
9. Call Control
10. Time and Date Setting
11. Remote Management Setup