ZyXEL Communications Parental Control Gateway HS100/HS100W - Manual (Page 184)

HomeSafe User’s Guide
14-2 Remote Management Screens
3. The IP address in the Secured Client IP field does not match the client IP address. If it
does not match, the HomeSafe will disconnect the session immediately.
4. There is already another remote management session with an equal or higher priority
running. You may only have one remote management session running at one time.
5. There is a firewall rule that blocks it.
14.1.2 Remote Management and NAT
When NAT is enabled:
¾ Use the HomeSafe’s WAN IP address when configuring from the WAN.
¾ Use the HomeSafe’s LAN IP address when configuring from the LAN.
14.1.3 System Timeout
There is a default system management idle timeout of five minutes (three hundred seconds). The
HomeSafe automatically logs you out if the management session remains idle for longer than this
timeout period. The management session does not time out when a statistics screen is polling.
You can change the timeout period in the System screen
14.2 Configuring WWW
To change your HomeSafe’s World Wide Web settings, click REMOTE MGMT to display the
WWW screen.
Figure 14-1 Remote Management : WWW
The following table describes the labels in this screen.
Table 14-1 Remote Management : WWW
LABEL DESCRIPTION
Server Port You may change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.