ZyXEL Communications Parental Control Gateway HS100/HS100W - Manual (Page 56)

HomeSafe User’s Guide
Introducing the Web Configurator 2-23
Table 2-17 Screens Summary
LINK TAB FUNCTION
PARENTAL
CONTROL
General Use this screen to enable/disable parental control, configure idle
timeout and group categories, register for content filtering service
and edit user profiles.
Bypass List Use this screen to allow devices in your network access the Internet
without using parental control.
Settings Use this screen to activate/deactivate the firewall and log packets
related to firewall rules.
Filter This screen allows you to block sites containing certain keywords in
the URL and set the days and times for the HomeSafe to perform
content filtering.
FIREWALL
Services Use this screen to enable service blocking.
TELNET Use this screen to configure through which interface(s) and from
which IP address(es) users can use Telnet to manage the
HomeSafe.
FTP Use this screen to configure through which interface(s) and from
which IP address(es) users can use FTP to access the HomeSafe.
WWW Use this screen to configure through which interface(s) and from
which IP address(es) users can use HTTP to manage the
HomeSafe.
SNMP Use this screen to configure your HomeSafe’s settings for Simple
Network Management Protocol management.
DNS Use this screen to configure through which interface(s) and from
which IP address(es) users can send DNS queries to the HomeSafe.
REMOTE MGMT
Security Use this screen to change your anti-probing settings.
UPnP UPnP Use this screen to enable UPnP on the HomeSafe.
View Log Use this screen to view the logs for the categories that you selected. LOGS
Log Settings Use this screen to change your HomeSafe’s log settings.
MAINTENANCE Status This screen contains administrative and system-related information.
DHCP Table This screen displays DHCP (Dynamic Host Configuration Protocol)
related information and is READ-ONLY.
Any IP Use this screen to allow a computer to access the Internet without
changing the network settings of the computer, when the IP
addresses of the computer and the HomeSafe are not in the same
subnet.
F/W Upload Use this screen to upload firmware to your HomeSafe.
Configuration Use this screen to backup and restore the configuration or reset the
factory defaults to your HomeSafe.
Restart This screen allows you to reboot the HomeSafe without turning the
power off.
LOGOUT Click this label to exit the web configurator.