ZyXEL Communications Parental Control Gateway HS100/HS100W - Manual (Page 37)

HomeSafe User’s Guide
2-4 Introducing the Web Configurator
Figure 2-4 Wizard Step 2 : Wireless LAN Setup Basic Security
The following table describes the labels in this screen.
Table 2-3 Wizard Step 2 : Wireless LAN Setup Basic Security
LABEL DESCRIPTION
WEP
Encryption Select 64-bit WEP or 128-bit WEP data encryption.
ASCII Select this option in order to enter ASCII characters as the WEP keys.
HEX Select this option to enter hexadecimal characters as the WEP keys.
The preceding “0x” is entered automatically.
Key 1 to Key 4 The WEP keys are used to encrypt data. Both the HomeSafe and the wireless stations must
use the same WEP key for data transmission.
If you chose 64-bit WEP, then enter any 5 ASCII characters or 10 hexadecimal characters
("0-9", "A-F").
If you chose 128-bit WEP, then enter 13 ASCII characters or 26 hexadecimal characters
("0-9", "A-F").
You must configure all four keys, but only one key can be activated at any one time. The
default key is key 1.
Back Click Back to display the previous screen.
Next Click Next to proceed to the next screen.
2.4.2 Step 2 : WLAN Setup Extended Security
If you choose Extend security in the Wireless LAN Setup screen, you can set up a Pre-Shared
Key.