ZyXEL Communications Parental Control Gateway HS100/HS100W - Manual (Page 326)

HomeSafe User’s Guide
D-4 Log Descriptions
Chart 5 ICMP Type and Code Explanations
TYPE CODE DESCRIPTION
0 Time to live exceeded in transit
1 Fragment reassembly time exceeded
12 Parameter Problem
0 Pointer indicates the error
13 Timestamp
0 Timestamp request message
14 Timestamp Reply
0 Timestamp reply message
15 Information Request
0 Information request message
16 Information Reply
0 Information reply message
Log Commands
Go to the command interpreter interface (Chapter 32 explains how to access and use the
commands).
Configuring What You Want the HomeSafe to Log
1. Use the sys logs load command to load the log setting buffer that allows you to configure which
logs the HomeSafe is to record.
2. Use sys logs category to view a list of the log categories.
Displaying Log Categories Example
Copyright (c) 1994 - 2004 ZyXEL Communications Corp.
HS-100W> ?
Valid commands are:
sys exit device ether
poe pptp config wlan
ip ppp bridge parentCtrl
radius 8021x
HS-100W>
3. Use sys logs category followed by a log category to display the parameters that are available
for the category.
Displaying Log Parameters Example
HS-100W> sys logs category access