ZyXEL Communications Parental Control Gateway HS100/HS100W - Manual (Page 266)

HomeSafe User’s Guide
Filter Configuration 27-3
27.2 Configuring a Filter Set
The HomeSafe includes filtering for NetBIOS over TCP/IP packets by default. To configure
another filter set, follow the procedure below.
Step 1. Enter 21 in the main menu to open menu 21.
Figure 27-4 Menu 21: Filter and Firewall Setup
Step 2. Enter 1 to bring up the following menu.
Figure 27-5 Menu 21.1: Filter Set Configuration
Step 3. Select the filter set you wish to configure (1-12) and press [ENTER] .
Step 4. Enter a descriptive name or comment in the Edit Comments field and press [ENTER].
Step 5. Press [ENTER] at the message [Press ENTER to confirm] to open Menu 21.1.1 -
Filter Rules Summary.
This screen shows the summary of the existing rules in the filter set. The following tables contain
a brief description of the abbreviations used in the previous menus.
Table 27-1 Abbreviations Used in the Filter Rules Summary Menu
FIELD DESCRIPTION
# The filter rule number: 1 to 6.
A Active: “Y” means the rule is active. “N” means the rule is inactive.
Type The type of filter rule: “GEN” for Generic, “IP” for TCP/IP.
Filter
Rules These parameters are displayed here.
Menu 21.1 - Filter Set Configuration
Filter Filter
Set # Comments Set # Comments
------ ----------------- ------ -----------------
1 _______________ 7 _______________
2 _______________ 8 _______________
3 _______________ 9 _______________
4 _______________ 10 _______________
5 _______________ 11 _______________
6 _______________ 12 _______________
Enter Filter Set Number to Configure= 0
Edit Comments= N/A
Press ENTER to Confirm or ESC to Cancel:
Menu 21 - Filter and Firewall Setup
1. Filter Setup
2. Firewall Setup
Enter Menu Selection Number: