ZyXEL Communications Parental Control Gateway HS100/HS100W - Manual (Page 230)

HomeSafe User’s Guide
Menu 3 LAN Setup 20-9
Figure 20-9 Menu 3.5 Wireless LAN Setup
Step 3. Move the cursor to the Edit Roaming Configuration field. Press [SPACE BAR] to select Yes
and then press [ENTER]. Menu 3.5.2 – Roaming Configuration displays as shown next.
Figure 20-10 Menu 3.5.2 Roaming Configuration
The following table describes the fields in this menu.
Table 20-6 Menu 3.5.2 Roaming Configuration
FIELD DESCRIPTION
Active Press [SPACE BAR] and then [ENTER] to select Yes to enable roaming on the HomeSafe if
you have two or more HomeSafe’s on the same subnet.
Port # Enter the port number to communicate roaming information between access points. The
port number must be the same on all access points. The default is 3517. Make sure this port
is not used by other services.
When you have completed this menu, press [ENTER] at the prompt “Press ENTER to confirm or ESC to
cancel” to save your configuration or press [ESC] to cancel and go back to the previous screen.
Menu 3.5.2 - Roaming Configuration
Active= Yes
Port #= 3517
Menu 3.5 - Wireless LAN Setup
ESSID= ZyXEL
Hide ESSID= No
Channel ID= CH06 2437MHz Edit MAC Address Filter= No
RTS Threshold= 2432 Edit Roaming Configuration= Yes
Frag. Threshold= 2432
WEP Encryption= Disable Preamble= Long
Default Key= N/A 802.11 Mode= Mixed
Key1= N/A
Key2= N/A
Key3= N/A
Key4= N/A
Authen. Method= N/A
Press ENTER to Confirm or ESC to Cancel: