ZyXEL Communications IES-708-22A - Manual (Page 66)

Chapter 5 Initial Configuration
IES-708-22A User’s Guide
66
"
If you change the IP address of the IES-708-22A, after you click Apply IP
setting, you have to use the new IP address to log into the web configurator
again.
4 If your subscribers use VPI 0 and VCI 33 (the default for all of the DSL ports), go to step
13 . Otherwise, use the following steps to change the VPI and VCI settings for all of the
DSL ports.
First, you will delete the default virtual channel from all of the DSL ports. (You cannot edit it).
Then, you will configure a new virtual channel for a port and copy it to the other DSL ports.
Adding another virtual channel without deleting the default virtual channel is not
recommended since you cannot set the new channel to be the port’s super channel. The super
channel can forward frames belonging to multiple VLAN groups (that are not assigned to
other channels). A channel that is not the super channel can only forward frames with a single
VLAN ID (that is configured on that channel). In this case, the IES-708-22A drops any frames
received from the subscriber that are tagged with another VLAN ID.
5 In the navigation panel, click Basic Setting > xDSL Port Setup. The xDSL Port Setup
screen appears.
Figure 17 xDSL Port Setup
6 Click VC Setup. The following screen appears.