ZyXEL Communications IES-708-22A - Manual (Page 129)

Chapter 14 xDSL Profiles Setup
IES-708-22A User’s Guide
129
End IP Enter the ending multicast IP address for a range of IP addresses to which you
want this IGMP filter profile to allow access.
If you want to add a single multicast IP address, enter it in both the Start IP and
End IP fields.
Add Click Add to save your changes to the IES-708-22A’s volatile memory. The IES-
708-22A loses these changes if it is turned off or loses power, so use the Config
Save link on the navigation panel to save your changes to the non-volatile
memory when you are done configuring.
Cancel Click Cancel to start configuring the screen again.
Table 28 Basic Setting > xDSL Profiles Setup > IGMP Filter Profile (continued)
LABEL DESCRIPTION