ZyXEL Communications IES-708-22A - Manual (Page 362)

Chapter 54 Virtual Channel Management
IES-708-22A User’s Guide
362
54.6 PPPoA to PPPoE (PAE) Commands
This feature is available in STU-C mode only.
You can use these commands to create PVCs for PAE translation.
54.6.1 PAE PVC Delete Command
Syntax:
ras> shdsl paepvc delete
where
This command removes a PAE PVC.
54.6.2 PAE PVC Set Command
Syntax:
ras> shdsl paepvc set
[acname ] [srvcname ] [hellotime
]
where
= The port number of the PAE PVC. You can specify a single DSL
port <1>, all DSL ports <*> or a list of DSL ports <1,3,5>. You
can also include a range of ports <1,5,6~8>.
= The VPI of the PAE PVC.
= The VCI of the PAE PVC.
= The port number of the PAE PVC. You can specify a single DSL
port <1>, all DSL ports <*> or a list of DSL ports <1,3,5>. You
can also include a range of ports <1,5,6~8>.
= The VPI of the PAE PVC.
= The VCI of the PAE PVC.
= Assign a VC profile to use for this channel’s downstream traffic
shaping.
[,US
vcprofile]> = Assign a VC profile to use for policing this channel’s upstream
traffic. The IES-708-22A does not perform upstream traffic
policing if you do not specify an upstream VC profile.
= 1 – 4094; the VLAN Identifier to add to Ethernet frames that the
system routes using this PVC.
= Set the IEEE 802.1p priority (0~7) to add to the traffic that uses
this PVC.