ZyXEL Communications IES-708-22A - Manual (Page 207)

Chapter 31 TLS PVC
IES-708-22A User’s Guide
207
Figure 105 Advanced Application > TLS PVC
The following table describes the labels in this screen.
Table 68 Advanced Application > TLS PVC
LABEL DESCRIPTION
Port Use this drop-down list box to select a port for which you wish to set up a TLS
PVC. This field is read-only once you click on a port number below.
VPI Type the Virtual Path Identifier for a channel on this port.
VCI Type the Virtual Circuit Identifier for a channel on this port.
DS VC Profile Use the drop-down list box to select a VC profile to use for this channel’s
downstream traffic shaping.
US VC Profile Use the drop-down list box to select a VC profile to use for this channel’s
upstream traffic. The IES-708-22A does not perform upstream traffic policing if
you do not specify an upstream VC profile.
Note: Upstream traffic policing should be used in conjunction with
the ATM shaping feature on the subscriber’s device. If the
subscriber’s device does not apply the appropriate ATM
shaping, all upstream traffic will be discarded due to
upstream traffic policing.
VID Type a VLAN ID to assign to frames received on this channel.
Note: Make sure the VID is not already used for PPPoA-to-
PPPoE conversions.
Priority Use the drop-down list box to select the priority value (0 to 7) to add to incoming
frames without a (IEEE 802.1p) priority tag.
Apply Click this to add or save channel settings on the selected port.
This saves your changes to the IES-708-22A’s volatile memory. The IES-708-
22A loses these changes if it is turned off or loses power, so use the Config
Save link on the navigation panel to save your changes to the non-volatile
memory when you are done configuring.
Cancel Click Cancel to start configuring the screen again.