ZyXEL Communications IES-708-22A User Manual
Page 60
Chapter 4 Introducing the Web Configurator
IES-708-22A User’s Guide
60
General Setup
Use this screen to configure general identification information about the device
and the time and date settings.
User Account
Use this screen to configure system administrator accounts.
Switch Setup
Use this screen to set up system-wide parameters such as MAC address
learning and priority queues.
IP Setup
Use this screen to configure the system and management IP addresses and
subnet masks.
ENET Port Setup
Use this screen to configure settings for the Ethernet ports.
xDSL Port Setup
Use these screens for configuring settings for individual DSL ports.
xDSL Profiles Setup Use these screens for configuring profiles for the DSL ports.
xDSL Line Data
Use these screens for viewing DSL line operating values, bit allocation and
performance counters.
G.bond
Use these screens to combine multiple ports into a logical link.
Advanced
Application
VLAN
Use these screens for viewing and configuring the VLAN settings.
IGMP
Use these screens to view IGMP status information and configure IGMP
settings and IGMP filters. You can also use these screens to set up bandwidth
requirements by multicast group or port and to set up limits on the number of
multicast groups to which a port can subscribe.
Static Multicast
Use this screen to configure static multicast entries.
Multicast VLAN
Use these screens to set up multicast VLANs that can be shared among
different subscriber VLANs on the network.
Filtering
Use this screen to configure packet filtering.
MAC Filter
Use this screen to configure MAC filtering for each port.
Spanning Tree
Protocol
Use these screens to display Rapid Spanning Tree Protocol (RSTP) information
and configure RSTP settings.
Port Authentication
Use these screens to configure RADIUS and IEEE 802.1x security settings.
Port Security
Use this screen to limit the number of MAC address that can be learned on a
port.
DHCP Relay
Use this screen to configure the DHCP relay settings.
DHCP Snoop
Use these screens to drop traffic from IP addresses not assigned by the DHCP
server and to look at a summary of the DHCP packets on each port.
2684 Routed Mode
Use this screen to configure the IES-708-22A to handle 2684 routed mode
traffic.
PPPoA to PPPoE
Use this screen to enable PPPoA-to-PPPoE conversions on each port.
DSCP
Use this screen to set up DSCP on each port and to convert DSCP values to
IEEE 802.1p values.
TLS PVC
Use this screen to set up Transparent LAN Service (VLAN stacking, Q-in-Q) on
each port.
ACL
Use this screen to set up Access Control Logic profiles and to assign them to
each PVC.
Downstream
Broadcast
Use this screen to block downstream broadcast packets from being sent to
specified VLANs on specified ports.
SysLog
Use this screen to configure the syslog settings.
Table 4 Web Configurator Screens (continued)
LABEL
DESCRIPTION