ZyXEL Communications IES-708-22A - Manual (Page 297)

Chapter 47 MAC Commands
IES-708-22A User’s Guide
297
47.3.3 MAC Count Disable Command
Syntax:
ras> switch mac count disable
where
This command disables the MAC filtering feature on the specified DSL port(s).
The following example turns off the MAC count filter on DSL port 4.
47.3.4 MAC Count Set Command
Syntax:
ras> switch mac count set
where
This command sets the limit for how many MAC addresses may be dynamically learned on
the specified DSL port(s).
The following example sets the MAC count filter to allow up to 50 MAC addresses to be
dynamically learned on DSL port 7.
= You can specify a single DSL port <1>, all DSL ports <*> or a
list of DSL ports <1,3,5>. You can also include a range of ports
<1,5,6~8>.
ras> switch mac count disable 4
= You can specify a single DSL port <1>, all DSL ports <*> or a
list of DSL ports <1,3,5>. You can also include a range of ports
<1,5,6~8>.
= Set the limit for how many MAC addresses that a port may
dynamically learn. For example, if you are configuring port 2
and you set this field to "5", then only five devices with
dynamically learned MAC addresses may access port 2 at any
one time. A sixth device would have to wait until one of the five
learned MAC addresses ages out.
The valid range is from “1” to “128”.
ras> switch mac count set 7 50