ZyXEL Communications IES-708-22A - Manual (Page 332)

Chapter 53 DSL Commands
IES-708-22A User’s Guide
332
When using 4 or 8-wire groups, you must apply the profile to every port in a specific set of
ports. For example, a profile for a 4-wire group can be used with ports 1,2 or 3,4 but not with
ports 2,3 or 4,5. A profile for an 8-wire group can be used with ports 1,2,3,4 or 5,6,7,8 but not
with ports 2,3,4,5 or 4,5,6,7.
The following example creates a premium profile (named gold) for providing subscribers with
very high connection speeds. The minimum transmission rate is 2112 Kbps and the maximum
transmission rate is 4096. It sets two ports to function as a 4-wire group. It uses G.992.1 Annex
A (DSL over POTS). It turns on line probes and has them use the current condition target
signal to noise ratio margin which it sets to 5 db.
53.1.6 DSL Port Profile Delete Command
Syntax:
ras> shdsl profile delete
where
This command allows you to delete an individual DSL profile by its name. You cannot delete
a profile that is assigned to any of the DSL ports in the IES-708-22A. Assign a different profile
to any DSL ports that are using the profile that you want to delete, and then you can delete the
profile.
The following example deletes the gold DSL profile.
53.1.7 DSL Port Profile Map Command
Syntax:
ras> shdsl profile map [pam mode]
where
ras> shdsl profile set gold 2112 4096 annexa 4wire lp_on_cur 5
= A profile name.
ras> shdsl profile delete gold
= You can specify a single DSL port <1>, all DSL ports <*> or a
list of DSL ports <1,3,5>. You can also include a range of ports
<1,5,6~8>.