ZyXEL Communications IES-708-22A - Manual (Page 266)

Chapter 43 Command Examples
IES-708-22A User’s Guide
266
43.2.3 Info Show Command
Syntax:
ras> sys info show
This command shows general system settings, the BIN (firmware) version, system uptime and
bootbase version.
An example is shown next.
43.3 Isolation Commands
This feature is available in STU-C mode only.
Turn on port isolation to block communications between subscriber ports. When you enable
port isolation, you do not need to configure the VLAN to isolate subscribers.
43.3.1 Isolation Show Command
Syntax:
ras> switch isolation show
This command displays the current setting of the subscriber isolation feature.
An example is shown next.
43.3.2 Isolation Enable Command
Syntax:
ras> switch isolation enable
ras> sys info show
Hostname:
Location:
Contact:
Model: IES-708-22A STU-R
ZyNOS version: V3.52(AYT.0)b2 | 08/29/2007
F/W size: 2310154
MAC address: 00:13:49:02:02:02
System up time: 1(days) : 5:22:44
Bootbase version: VAYS1.01 | 07/20/2007
F/W build date: Sep 4 2007 19:54:47
Driver version: 0.9.1.0
DSP code version: 1.1-1.5.0__004
Hardware version:
Serial number:
ras> switch isolation show
system isolation: enabled
system switch mode : stand alone