Table 48 advanced application > mac filter – ZyXEL Communications IES-708-22A User Manual
Page 168

Chapter 22 MAC Filter
IES-708-22A User’s Guide
168
The following table describes the labels in this screen.
Table 48 Advanced Application > MAC Filter
LABEL
DESCRIPTION
Port
Use this drop-down list box to select a DSL port for which you wish to configure
MAC filtering.
MAC
Type a device’s MAC address in hexadecimal notation (xx:xx:xx:xx:xx:xx, where
x is a number from 0 to 9 or a letter from a to f) in this field. The MAC address
must be a valid MAC address.
Add
Click Add to save your changes to the IES-708-22A’s volatile memory. The IES-
708-22A loses these changes if it is turned off or loses power, so use the Config
Save link on the navigation panel to save your changes to the non-volatile
memory when you are done configuring.
Cancel
Click Cancel to begin configuring this screen afresh.
Port
These are the numbers of the DSL ports.
Mode
Select Accept to only allow frames from MAC addresses that you specify and
block frames from other MAC addresses.
Select Deny to block frames from MAC addresses that you specify and allow
frames from other MAC addresses.
Active
Select this check box to turn on MAC filtering for a port.
MAC
This field lists the MAC addresses that are set for this port.
Delete
Click Delete to remove a MAC address from the list.
Apply
Click Apply to save your changes to the IES-708-22A’s volatile memory. The
IES-708-22A loses these changes if it is turned off or loses power, so use the
Config Save link on the navigation panel to save your changes to the non-
volatile memory when you are done configuring.