Syslog, 1 syslog, 2 syslog screen – ZyXEL Communications IES-708-22A User Manual
Page 217: Chapter 34 syslog, 1 syslog 34.2 syslog screen, Figure 110 advanced application > syslog, Table 73 advanced application > syslog, Syslog (217)
IES-708-22A User’s Guide
217
C
H A P T E R
34
SysLog
This chapter explains how to set the syslog parameters.
34.1 Syslog
The syslog feature sends logs to an external syslog server.
34.2 SysLog Screen
To open this screen, click Advanced Application > SysLog.
Figure 110 Advanced Application > SysLog
The following table describes the labels in this screen.
Table 73 Advanced Application > SysLog
LABEL
DESCRIPTION
Enable Unix Syslog
Select this check box to activate syslog (system logging) and then configure the
syslog parameters described in the following fields.
Syslog Server IP
Enter the IP address of the syslog server. (The log facility is specified in Alarm >
Alarm Event Setup. See
Apply
Click Apply to save your changes to the IES-708-22A’s volatile memory. The
IES-708-22A loses these changes if it is turned off or loses power, so use the
Config Save link on the navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Cancel
Click Cancel to begin configuring this screen afresh.