ZyXEL Communications IES-708-22A - Manual (Page 290)

Chapter 46 IEEE 802.1Q Tagged VLAN Commands
IES-708-22A User’s Guide
290
46.4.8 Configuring Management VLAN Example
"
After the following example configuration, you must connect to the first
Ethernet port through a VLAN aware device that is using the proper VLAN ID
in order to perform management.
By default, the IES-708-22A’s DSL ports are members of the management VLAN (VID 1).
The following procedure shows you how to configure a tagged VLAN that limits management
access to just one Ethernet port.
"
Use the console port to configure the IES-708-22A if you misconfigure the
management VLAN and lock yourself out.
1 Use the switch vlan set command to configure a VLAN ID (VID 3 in this example)
for managing the IES-708-22A (the “management” or “CPU” VLAN).
2 Use the switch vlan1q vlan cpu command to set VID 3 as the management
VLAN.
46.4.9 VLAN Delete Command
Syntax:
ras> switch vlan delete
where
This command deletes the specified VLAN ID entry from the static VLAN table. The
following example deletes entry 2 in the static VLAN table.
ras> switch vlan set 3 enet1:FT
ras> switch vlan cpu set 3
= You can specify a single VID: <1>, all VIDs: <*>, a list of
VIDs: <1,3>, you can also include a range of VIDs: <1,5,6~8>.
ras> switch vlan delete 2