ZyXEL Communications IES-708-22A - Manual (Page 303)

Chapter 48 IGMP Commands
IES-708-22A User’s Guide
303
The following example displays the voice IGMP filter profile’s settings.
48.4 IGMP Bandwidth Commands
This feature is available in STU-C mode only.
Use the IGMP bandwidth commands to set up bandwidth budgets for specific multicast
channels.
48.4.1 IGMP Bandwidth Default Command
Syntax:
ras> switch igmpsnoop bandwidth default
where
This command sets the default bandwidth for multicast channels for which you have not
configured bandwidth requirements yet. Multicast bandwidth settings on channels (using the
switch igmpsnoop bandwidth set command) have higher priority over this default
setting.
48.4.2 IGMP Bandwidth Set Command
Syntax:
ras> switch igmpsnoop bandwidth set
ras> switch igmpfilter profile show voice
profile index startip endip
-------------------------------------------------------------------------
voice 1 224.1.1.10 224.1.1.44
voice 2 0.0.0.0 0.0.0.0
voice 3 0.0.0.0 0.0.0.0
voice 4 0.0.0.0 0.0.0.0
voice 5 0.0.0.0 0.0.0.0
voice 6 0.0.0.0 0.0.0.0
voice 7 0.0.0.0 0.0.0.0
voice 8 0.0.0.0 0.0.0.0
voice 9 0.0.0.0 0.0.0.0
voice 10 0.0.0.0 0.0.0.0
voice 11 0.0.0.0 0.0.0.0
voice 12 0.0.0.0 0.0.0.0
voice 13 0.0.0.0 0.0.0.0
voice 14 0.0.0.0 0.0.0.0
voice 15 0.0.0.0 0.0.0.0
voice 16 0.0.0.0 0.0.0.0
= Allowed bandwidth between 1 and 100000 kbps (kilo bits per
second).