ZyXEL Communications IES-708-22A User Manual
Page 109
Chapter 13 xDSL Port Setup
IES-708-22A User’s Guide
109
Figure 45 Basic Setting > xDSL Port Setup > VC Setup
The following table describes the labels in this screen.
Table 20 Basic Setting > xDSL Port Setup > VC Setup
LABEL
DESCRIPTION
xDSL Port Setup
Click xDSL Port Setup to go to the screen where you can configure DSL port
PPVC Setup
(STU-C mode only) Click PPVC Setup to open the PPVC Setup screen where
you can configure priority PVC settings for the DSL ports (see
Port
Use this drop-down list box to select a port for which you wish to view or
configure settings. This field is read-only once you click on a port number below.
Super Channel
The IES-708-22A forwards frames belonging to VLAN groups that are not
assigned to specific channels to the super channel.
Enable the super channel option to have this channel forward frames belonging
to multiple VLAN groups (that are not assigned to other channels).
The super channel functions in the same way as the channel in a single channel
environment.
VPI
Type the Virtual Path Identifier for a channel on this port.
VCI
Type the Virtual Circuit Identifier for a channel on this port.
DS VC Profile
Use the drop-down list box to select a VC profile to use for this channel’s
downstream traffic shaping.
US VC Profile
Use the drop-down list box to select a VC profile to use for this channel’s
upstream traffic. The IES-708-22A does not perform upstream traffic policing if
you do not specify an upstream VC profile.
Note: Upstream traffic policing should be used in conjunction with
the ATM shaping feature on the subscriber’s device. If the
subscriber’s device does not apply the appropriate ATM
shaping, all upstream traffic will be discarded due to
upstream traffic policing.