ZyXEL Communications IES-708-22A - Manual (Page 126)

Chapter 14 xDSL Profiles Setup
IES-708-22A User’s Guide
126
14.8.1 Alarm Profile Map Screen
Use this screen to look at and to assign the ports to which alarm profiles are assigned. The IES-
708-22A loses these changes if it is turned off or loses power, so use the Config Save link on
the navigation panel to save your changes to the non-volatile memory when you are done
configuring.
To open this screen, click Basic Setting > xDSL Profiles Setup > Alarm Profile > Show
Map.
Figure 56 Basic Setting > xDSL Profiles Setup > Alarm Profile > Map
The following table describes the labels in this screen.
UAS The number of UnAvailable Seconds (0~900) that are permitted to occur within
15 minutes.
Index This is the index number of the alarm profile.
Name This is the name of the alarm profile.
Show Map
Select
Modify Select a profile’s Select radio button and click Modify to edit the profile
Delete Select a profile’s Select radio button and click Delete to remove the profile
Table 26 Basic Setting > xDSL Profiles Setup > Alarm Profile (continued)
LABEL DESCRIPTION
Table 27 Basic Setting > xDSL Profiles Setup > Alarm Profile > Map
LABEL DESCRIPTION
Alarm Profile Name This field displays the name of the alarm profile displayed in this screen.
Port This field displays the DSL port number.
Stuc This field displays whether or not the alarm profile is assigned to this port as the
alarm profile for the STU-C end point. It displays V if it is assigned, and it
displays - if it is not assigned. Click - to assign this profile to the port for the
STU-C end point.
Stur This field displays whether or not the alarm profile is assigned to this port as the
alarm profile for the STU-R end point. It displays V if it is assigned, and it
displays - if it is not assigned. Click - to assign this profile to the port for the
STU-R end point.