ZyXEL Communications IES-708-22A - Manual (Page 363)

Chapter 54 Virtual Channel Management
IES-708-22A User’s Guide
363
This command creates a PPPoA-to-PPPoE PVC to allow communication between the ATM
(CPE) and Ethernet network (BRAS) segments. The PVC is mapped to a PPPoE session that
connects to the specified BRAS.
The following example creates a PPPoA-to-PPPoE PVC (
1/33 ) for port 1 . The VLAN ID is
1, and the IEEE 802.1p priority is 0. This configuration is for the video service on the vom
access concentrator. The IES-708-22A waits 10 seconds before terminating the PPPoE
session.
54.6.3 PAE PVC Show Command
Syntax:
ras> shdsl paepvc show [ [ ]]
where
This command displays the PPPoA-to-PPPoE PVC settings for the specified port(s) or PVCs.
The following example displays the settings for port 1.
= This field is optional. Specify the hostname of a remote access
concentrator if there are two access concentrators (or BRAS) on
the network or that you want to allow PAE translation to the
specified access concentrator.
= This field is optional. Specify the name of the service that uses
this PVC. This must be a service name that you configure on the
remote access concentrator.
= 0 - 600; specify the timeout, in seconds, for the PPPoE session.
Enter 0 if there is no timeout.
ras> shdsl paepvc set 1 1 33 DEFVAL 1 0 acname vom srvcname video hellotime
10
= The port number of the PAE PVC. You can specify a single DSL
port <1>, all DSL ports <*> or a list of DSL ports <1,3,5>. You
can also include a range of ports <1,5,6~8>.
= The VPI of the PAE PVC.
= The VCI of the PAE PVC.
ras> shdsl paepvc show 1
port vpi vci pvid pri htime US/DS vcprofile/acname/srvcname
---- --- ----- ---- --- ----- -----------------------------------
1 1 33 1 0 10 dsprofile: DEFVAL
usprofile:
acname : vom
srvcname : video