ZyXEL Communications IES-708-22A - Manual (Page 271)

Chapter 44 Alarm Commands
IES-708-22A User’s Guide
271
The following example displays the port alarm thresholds for all ports. “ifindex” identifies the
interface.
44.5 Alarm Port Set Command
Syntax:
ras> alarm port set >
where
This command sets the alarm severity threshold for recording alarms on an individual port(s).
The system reports an alarm on a port if the alarm has a severity equal to or higher than the
port’s threshold.
The following example has the IES-708-22A only record critical alarms on DSL port 7.
44.6 Alarm Tablelist Command
Syntax:
ras> alarm tablelist [|all] [|all] [|all]
[[,]] [|all]
where
ras> alarm port show
no ifindex severity
------ ------- --------
01 01 minor
02 02 minor
03 03 minor
04 04 minor
05 05 minor
==================================== SNIP =================================
= Ports on the IES-708-22A.
= Alarm severity. info|minor|major|critical
ras> alarm port set 7 critical
= Alarm category. sys|eqpt|enet|dsl|voip
= Alarm severity. info|minor|major|critical
= The log facility ( local1~local7 ) that has the device log the
syslog messages to different files in the syslog server. See your
syslog program’s documentation for details.