ZyXEL Communications IES-708-22A - Manual (Page 150)

Chapter 18 IGMP
IES-708-22A User’s Guide
150
18.4 IGMP Bandwidth Screen
This feature is available in STU-C mode only.
Use this screen to set up bandwidth requirements for multicast channels. To open this screen,
click Advanced Application > IGMP > Bandwidth Setup.
Figure 68 Advanced Application > IGMP > Bandwidth Setup
The following table describes the labels in this screen.
Index This is the IGMP group index number.
VID The VID is the VLAN ID on which the IGMP group is created.
IP Address This is the IP address of an IP multicast group member.
1~8, enet1, enet2 These columns indicate whether or not each port is a member of the IGMP
snooping group.
Table 36 Advanced Application > IGMP (continued)
LABEL DESCRIPTION
Table 37 Advanced Application > IGMP > Bandwidth Setup
LABEL DESCRIPTION
Port Setup Click Port Setup to open the Bandwidth Port Setup screen where you can set
up multicast bandwidth requirements on specified ports (see Section 18.4.1 on
page 151 ).
Default Bandwidth Enter the default bandwidth for multicast channels for which you have not
configured bandwidth requirements.
Apply Click Apply to save your changes to the IES-708-22A’s volatile memory. The
IES-708-22A loses these changes if it is turned off or loses power, so use the
Config Save link on the navigation panel to save your changes to the non-
volatile memory when you are done configuring.