ZyXEL Communications IES-708-22A - Manual (Page 304)

Chapter 48 IGMP Commands
IES-708-22A User’s Guide
304
where
This command configures bandwidth allocation for the multicast channel(s). For multicast
channel(s) for which you have not configured bandwidth settings, the default multicast
bandwidth setting applies (see the
switch igmpsnoop bandwidth default command).
48.4.3 IGMP Bandwidth Delete Command
Syntax:
ras> switch igmpsnoop bandwidth delete
where
This command removes the specified multicast bandwidth configuration profile.
48.5 IGMP Bandwidth Port Commands
This feature is available in STU-C mode only.
Use the IGMP bandwidth port commands to set up bandwidth budgets for multicast traffic on
specific ports.
48.5.1 IGMP Bandwidth Port Disable Command
Syntax:
ras> switch igmpsnoop bandwidth port disable
where
This command deactivates multicast bandwidth settings of the specified port.
= 1..96; a unique number for this setting.
ip> = 224.0.0.0..239.255.255.255; the beginning of the multicast
range.
= 224.0.0.0..239.255.255.255; the end of the multicast range. It
must be greater than .
= 1..100000, in units of kbps
= 1..96; a unique number for this setting.
= You can specify a single DSL port <1>, all DSL ports <*> or a
list of DSL ports <1,3,5>. You can also include a range of ports
<1,5,6~8>.