ZyXEL Communications IES-708-22A - Manual (Page 234)

Chapter 37 Alarm
IES-708-22A User’s Guide
234
Figure 120 Alarm > Alarm Port Setup
The following table describes the labels in this screen.
Table 85 Alarm > Alarm Port Setup
LABEL DESCRIPTION
Alarm Status Click Alarm Status to go to a screen that displays the alarms that are currently
in the system (see Section 37.2 on page 229 ).
Alarm Event Setup Click Alarm Event Setup to go to a screen where you can configure the
severity level of an alarm(s) and where the system is to send the alarm(s). See
Section 37.4 on page 231 .
Port This column lists the device’s individual DSL and Ethernet interfaces.
Severity Select an alarm severity level (Critical, Major, Minor or Info) as the threshold
for recording alarms on this port. Critical alarms are the most severe, major
alarms are the second most severe, minor alarms are the third most severe and
info alarms are the least severe.
Apply Click Apply to save your changes to the IES-708-22A’s volatile memory. The
IES-708-22A loses these changes if it is turned off or loses power, so use the
Config Save link on the navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Cancel Click Cancel to start configuring the screen again.