ZyXEL Communications IES-708-22A - Manual (Page 144)

Chapter 17 VLAN
IES-708-22A User’s Guide
144
Figure 64 Advanced Application > VLAN > VLAN Port Setting
The following table describes the labels in this screen.
Table 35 Advanced Application > VLAN > VLAN Port Setting
LABEL DESCRIPTION
VLAN Status Click VLAN Status to see which of the IES-708-22A’s ports are members of
which VLANs (see Section 17.3 on page 140 ).
Static VLAN Click Static VLAN to configure ports to dynamically join a VLAN group or
permanently assign ports to a VLAN group or prohibit ports from joining a VLAN
group (see Section 17.4 on page 142 ).
Port The port numbers identify the IES-708-22A’s ports.
PVID Type the Port VLAN ID (PVID) from 1 to 4094. The IES-708-22A assigns the
PVID to untagged frames or priority frames (0 VID) received on this port.
Priority Select an IEEE 802.1p priority to assign to untagged frames or priority frames (0
VID) received on this port.
GVRP (STU-C mode only) Select this check box if the IES-708-22A should use GVRP
to automatically register and configure VLAN membership.
Acceptable Frame
Type
Select All to have the port accept both tagged and untagged incoming frames. A
Select Tag Only to have the port only accept incoming frames that have a
VLAN tag.
Apply Click Apply to save your changes to the IES-708-22A’s volatile memory. The
IES-708-22A loses these changes if it is turned off or loses power, so use the
Config Save link on the navigation panel to save your changes to the non-
volatile memory when you are done configuring.