Dsl commands, 1 dsl port commands, 1 dsl port show command – ZyXEL Communications IES-708-22A User Manual
Page 329: 2 dsl port enable command, Chapter 53 dsl commands, Dsl commands (329)
IES-708-22A User’s Guide
329
C
H A P T E R
53
DSL Commands
This chapter describes some of the commands that allow you to configure and monitor the
DSL ports.
53.1 DSL Port Commands
Use these commands to configure the DSL ports. See
for background
information on DSL and SHDSL.
53.1.1 DSL Port Show Command
Syntax:
ras> shdsl show [portlist]
where
This command shows the activation status, DSL mode, maximum upstream and downstream
rate settings, and DSL profile of each DSL port. It also provides subscriber information for the
port.
The following example displays information on DSL port 1.
53.1.2 DSL Port Enable Command
Syntax:
ras> shdsl enable
[portlist]
=
You can specify a single DSL port <1>, all DSL ports <*> or a
list of DSL ports <1,3,5>. You can also include a range of ports
<1,5,6~8>.
ras> shdsl show 1
port enable mode min/max rate pam profile
---- ------ ---- ------------- ----- -------------------------------
1 V stur 192/ 2304 auto DEFVAL
Subscriber Info:
port name tel
---- -------------------------------- ----------------
1 - -