B.1 understanding the parameter table, Control modes, symbols, and terms – Yaskawa L1000E AC Drive Technical Manual for CIMR-LE Models for Elevator Applications User Manual

Page 366

366

YASKAWA ELECTRIC SIEP YAIL1E 01A YASKAWA AC Drive L1000E Technical Manual

B.1 Understanding the Parameter Table

◆ Control Modes, Symbols, and Terms

The table below lists terms and symbols used in this section to indicate which parameters are available in which control
modes.

Note:

Refer to Control Mode Selection on page 28

for detailed instructions on each control mode.

Table B.1 Symbols and Icons Used in the Parameter Table

Note: If a parameter is not available in a certain control mode, the symbol for that control mode is grayed out.

Symbol

Description

Parameter is available in all control modes.

Parameter is available when operating the drive with V/f Control.

Parameter is available when operating the drive with Open Loop Vector.

Parameter is available when operating the drive with Closed Loop Vector.

Parameter is available when operating the drive with Closed Loop Vector for PM motors.

Parameter can be changed during run.

Motor 2

Refers to a second motor when the drive is operating two motors. Switch between these motors using the multi-function input terminals.

All Modes

V/f

OLV

CLV

CLV/PM