Yaskawa L1000E AC Drive Technical Manual for CIMR-LE Models for Elevator Applications - Manual (Page 263)

5.11 S: Elevator Parameters
YASKAWA ELECTRIC SIEP YAIL1E 01A YASKAWA AC Drive L1000E Technical Manual 263
P
a
ra
me
te
r De
ta
ils
5
■ S6-05: Brake Response Error (SE4) Detection Time
Sets a delay time for detecting a brake response error (SE4). SE4 is detected when an output terminal set for “Brake
release” (H2-†† = 50) and an input terminal set for “Brake feedback” (H1-†† = 79) do not match for the time set to
S6-05.
■ S6-10: Overacceleration Detection Level
If the elevator car accelerates at an abnormal rate, the drive triggers an overacceleration fault (dv6) and the motor coasts
to stop. Parameter S6-10 determines the acceleration rate that triggers the dv6 fault. A setting of 0.0 m/s
2 disables
overacceleration detection.
■ S6-11: Overacceleration Detection Time
Sets the time that the acceleration must exceed the overacceleration detection level before as fault is triggered.
■ S6-12: Overacceleration Detection Selection
Determines the conditions for detecting an overacceleration situation.
Setting 0: Always enabled
Setting 1: During run only
■ S6-15: Speed Reference Loss Detection
Enabled or disables detection for missing speed reference (FrL).
Setting 0: Disabled
Setting 1: Enabled
■ S6-16: Restart after Baseblock Selection
Allows the drive to restart the motor after returning to normal operation from Baseblock state (H1-†† = 8/9) or from
Safe Torque-Off state (Safe Disable inputs H1 and H2 enabled) while the Up/Down command is still active.
Setting 0: No restart after Baseblock or Safe Torque-Off
Do not restart the motor when leaving the Baseblock or Safe Torque-Off state even if an Up/Down command is still
active.
No. Parameter Name Setting Range Default
S6-05 Brake Response Error (SE4) Detection Time 0 to 10000 ms 500 ms
No.
<1> Default setting is determined by parameter o1-03. If o1-03 is set to 0 through 5, the default is 1.5 m/s 2 . If o1-03 is set to 6, the default is
5.0 ft/s 2 (setting range: 0.0 to 50.0 ft/s 2 ).
Parameter Name Setting Range Default
S6-10 Overacceleration Detection Level 0.0 to 20.0 m/s 2 1.5 m/s 2 <1>
No. Parameter Name Setting Range Default
S6-11 Overacceleration Detection Time 0 to 5000 ms 50 ms
No. Parameter Name Setting Range Default
S6-12 Overacceleration Detection Selection 0 or 1 0
No. Parameter Name Setting Range Default
S6-15 Speed Reference Loss Detection 0 or 1 1
No. Parameter Name Setting Range Default
S6-16 Restart after Baseblock Selection 0 or 1 0