Yaskawa L1000E AC Drive Technical Manual for CIMR-LE Models for Elevator Applications - Manual (Page 341)

8.4 Option Card Installation
YASKAWA ELECTRIC SIEP YAIL1E 01A YASKAWA AC Drive L1000E Technical Manual 341
Per
iphe
ra
l De
vi
ce
s &
Optio
n
s
8
5. For the PG-B3 and PG-X3 Option, wire the motor PG encoder to the terminal block. Refer to Figure 8.8 and
Figure 8.9 for wiring instructions.
Refer to Terminal Functions of PG-B3 and PG-X3 Option on page 346 for a detailed description of the option
terminal functions.
Connection Diagram of PG-B3
Refer to Table 8.9 for a detailed description of the option board terminal functions.
Figure 8.8 PG-B3 Option and Encoder Connection Diagram
<1> The PG-B3 Option reads a maximum input frequency from the PG encoder of 50 kHz. Be sure to select an PG encoder with a maximum output
pulse frequency of 50 kHz when operating at maximum speed.
Twisted-pair shielded line
Main circuit terminal Control circuit terminal
M
A+
A
B
Z
B+
Z+
AO
IG
BO
IG
ZO
IG
FE
IP
IG
TB1
SD
TB2
NC
CN5-B
or
CN5-C
PG B3
Option
U/T1
V/T2
W/T3
R/L1
S/L2
T/L3
FE
YASKAWA
Drive
Ground wire
A pulse monitor signal
B pulse monitor signal
Z pulse monitor signal
PG
3
4
5
6
E
1
2
B 3