Yaskawa PC NC - Manual (Page 97)

3 - 40
YASNAC PCNC Operating Manual Chapter 3: HMI Process Operation
The Open Folder button is enabled whenever a directory is selected in the file list.
Whenever a directory is opened, its contents are displayed in the file list area, and the
directory name is displayed in the tab at the top.
The Move button is used to remove a file from the directory specified in the first (Source)
tab, and add it to the directory shown in the second (Destination) tab. The file name does
not change.
The Copy button is used to make a copy of the file selected in the first (Source) tab, and
place that copy in the directory specified in the second (Destination) tab. This button is
disabled if no file is selected in the source directory. A Confirm File Replace dialog pops
if performing the copy will overwrite an existing program. It is possible to copy multiple pro-
grams all at once.
Note: The Copy, Move and Duplicate functions all check for available disk space. New files are
not allowed if less than 1024 bytes are available on the destination drive. Rename, Delete, Move,
Copy and Duplicate are disabled if Edit Lock is on.
There are several parameters that control whether macro programs (programs in the 8000 and
9000 ranges) can be displayed or edited. These parameters are listed in Table 3.4.1.1 on page 40.
The effects of combining these parameters are outlined in Table 3.4.1.2 on page 40 and
Table 3.4.1.3 on page 41.
Table 3.4.1.1: Macro Lock Parameters
Address Bit
pm 20 0 Permits/prohibits display and edit of O8000 - O8999
pm 21 0 Permits/prohibits edit of O8000 - O8999
pm 22 0 Permits/prohibits edit of O9000 - O9999
pm 3004 0 Permits/prohibits display and edit of O9000 - O9999
Table 3.4.1.2: Parameters Controlling O8000 - O8999
pm 21 (edit) pm 20 (display) Copy, Rename, Delete,
Edit, Duplicate, Move
View
permitted permitted yes yes
permitted prohibited no no
prohibited permitted no yes
prohibited prohibited no no