Yaskawa PC NC - Manual (Page 282)

A3 - 42
YASNAC PCNC Operating Manual APPENDIX 3: Parameter Tables
Basic
Address Bit Description
Register
Units
Minimum
Value
Maximum
Value
Long Description
1240 Spindle number for executing
solid tap 0 1
1241 Servo axis number for executing
solid tap 1 5
1252 Return feedrate multiplication
for solid tap 0.1times 1 255
1260 Spindle loop control gear number
(A) 0 4
1261 Spindle loop control gear number
(B) 0 4
1321 1st axis Error detect-ON area 0.001mm 0 255
1322 2nd axis Error detect-ON area 0.001mm 0 255
1323 3rd axis Error detect-ON area 0.001mm 0 255
1324 4th axis Error detect-ON area 0.001mm 0 255
1325 5th axis Error detect-ON area 0.001mm 0 255
1331 Error detect-ON area during spindle
loop 0.001mm 0 255
1351 Servo error range when spindle loop
control % 0 255 Spindle, Multiplication
relative to rapid feed in
servo error range
1416 Maximum spindle speed during
solid tap r/min 0 32767
1417 Spindle position loop gain for
solid tap 0.01[1/S] 0 32767
1418 Spindle C-axis, max speed
corresponding to 10V r/min 0 666 Maximum spindle
speed corresponding to
10 V of command
(C-axis is used)
1419 Spindle gear A base speed r/min 0 32767
1500 Solid tap servo shaft retraction
in-position 0.001mm 0 32767
1502 Solid tap synchronization offset
parameter K1 -32767 32767
1503 Solid tap synchronization offset
parameter K2 -32767 32767
1510 No. of teeth of gear A on the
spindle side tooth 0 32767 No. of teeth of gear A
on the spindle side for
spindle loop control
1511 No. of teeth of gear A on the
spindle intermediate tooth 0 32767 No. of teeth of the
spindle intermediate
gear A used for spindle
loop control If there is
no intermediate gear,
set motor side one