Yaskawa PC NC - Manual (Page 75)

3 - 18
YASNAC PCNC Operating Manual Chapter 3: HMI Process Operation
The Forward arrow will go to the screen that is the next in the screen list. This is dis-
abled if the user has never used the back arrow.
Using the Backward and Forward buttons:
• Change to the Run:Production screen.
• Change to the Tools:Offset screen. The Back button should now be enabled.
• Press the Back button on the toolbar. The Run:Production screen should now be showing,
and the Forward button should be enabled.
• Press the Forward button on the toolbar. The Tools:Offset screen should now be showing,
and the Back button should be enabled.Menu Bar
3.1.10 Menu Bar
The menubar contains the reset button and top level menu items. The latter will be discussed in
subsequent chapters.
FIGURE 3.1.10.1. Menubar
The Reset button appears in the bottom left corner of the screen, just to the left of the top
level menu. Pressing this button will halt NC operation and reset it to an idle state with the
program counter back at 0. The running pointer arrow will appear at the top of the program
display.