Yaskawa PC NC - Manual (Page 309)

A3 - 69
YASNAC PCNC Operating Manual APPENDIX 3: Parameter Tables
1000 1 Spindle output when
AFL signal is ON 0 1
2 Override setting on spindle speed
output 0 1
4 Filter for spindle load and speed 0 1 Filtering in the I/O out
put for the spindle load
and speed monitor
5 SSTP enable setting 0 1 SSTP setting for “0” out-
put in response to “0” S
command
7 SAGR check when rapid to feed 0 1 Checking of SAGR
when feed rate is
changed from rapid to
feed
1001 0 Output sign of S in S5-digit
command 0 3
1002 0 Magnification ratio of spindle speed 0 1
1003 2 D/A output status is input to the
PLC 0 1
1020 0 1st axis YENET station number 0 15 1st Physical servo axis
YENET1200
station number
setting (No. 2 to
No. 15 station)
5 1st axis debug mode 0 1
6 1st axis Physical servo axis
specifications 0 1
7 1st axis Physical servo axis enable 0 1
1021 0 2nd axis YENET station number 0 15 2nd Physical servo axis
YENET1200
station number
setting (No. 2 to
No. 15 station)
5 2nd axis debug mode 0 1
6 2nd axis Physical servo axis
specifications 0 1
7 2nd axis Physical servo axis enable 0 1
1022 0 3rd axis YENET station number 0 15 3rd Physical servo axis
YENET1200
station number
setting (No. 2 to
No. 15 station)
5 3rd axis debug mode 0 1
6 3rd axis Physical servo axis
specifications 0 1
7 3rd axis Physical servo axis enable 0 1
Address Bit Description
Register
Units
Minimum
Value
Maximum
Value
Long Description