Yaskawa PC NC - Manual (Page 180)

4 - 18
YASNAC PCNC Operating Manual Chapter 4: Maintenance
(e) Other related parameters
Check the setting for the following parameters.
(3) Jog Operation is Impossible
(a) Jog mode signal is not input
Check the bit status of I/O monitor #3000.
Dl = l
Other bits (DO, D2 to D7) = O
(b) Axis move direction signal is not input.
Check the bit status of I/O monitor #3071 and #3072.
Maximum feedrate for handle operation
Parameter pm2860 (linear axis)
Parameter pm2861 (rotary axis)
Acceleration/deceleration time constant Parameters pm2561 to pm2565
Pulse multiplication ratio of “×100” is set (pm2003 D7 = 1) Parameter pm2549
#3071 #3072
D0 +1st axis D0 -1st axis
Dl +2nd axis Dl -2nd axis
D2 +3rd axis D2 -3rd axis
D3 +4th axis D3 -4th axis
D4 +5th axis D4 -5th axis