Yaskawa PC NC - Manual (Page 82)

3 - 25
YASNAC PCNC Operating Manual Chapter 3: HMI Process Operation
3.3 RUN MENU
3.3.1 Production Screen
FIGURE 3.3.1.1. The Run Production Screen
This screen normally displayed during production. The screen includes a Program Display
described in “Program Display” on page 20, two non-editable Position Displays, discussed in
“Position Display” on page 19, and other production data. The choice of coordinate systems is
preserved when the MMI is shut down so that at restart the same coordinate systems are dis-
played.
In the upper left corner of the screen is an area containing program-specific data. This data
includes the current program, sequence number,Tool commanded,Speed and ATC tool num-
bers. The commanded tool number indicates the tool in use. The Spindle tool and ATC tool (tool
currently held in the tool changer) are also shown.
The formatting of the tools is controlled by parameters, which is the way the Spindle and ATC
tools are read.